5
MN-753
Air Lift 1000
6. Push the air line onto the stem, covering all the barbs (Fig. 6). With the pliers, slide the
air line clamp upward until it fully covers the barbed section.
7. Push the remaining air line over the last fitting on the tee and route it along the frame
to the desired inflation valve location. Attach the air line with plastic straps or wire.
8. Select a location for the inflation valve in the gas cap well, the trunk, rear bumper, fender
flange or behind license plate, insuring that the valve will be protected and accessible
with an air hose (Fig. 7).
9. Drill a 5/16
”
(8mm) hole for the inflation valve and mount as shown (Fig. 8). The rubber
washer serves as an outside weather seal.
10. Slide the air line clamp over the air line. Push the air line onto the fitting covering all
barbs. Using pliers, slide the air line clamp forward until it fully covers the barbed section
(Fig. 9).
DO NOT INFLATE AIR SPRINGS BEFORE READING THE MAINTENANCE AND
OPERATION SECTION.
A
B
C
Use this procedure for all air
line connections:
a. Slide the air line clamp onto
the air line.
b. Push the air line over the
barbed stem.
c. Compress the ears on the
air line clamp with pliers and
slide it forward to fully cover
the barbed section.
Fig. 5
Option 1
Option 2
Fig. 7
Fig. 6
Stem
Air line
Fig. 9
Fig. 8
Be sure to fully cover
the barbed section.
Vehicle body
or bumper
Air line
clamp
Hex nut
Rubber
washer
Lock
washer
Inflation
valve
Flat washer
Air line
Hex nut
CAUTION
Содержание Air Lift 1000 60818
Страница 2: ......
Страница 15: ...13 MN 753 Air Lift 1000 Notes...
Страница 16: ...14 MN 753 Air Lift 1000 Notes...
Страница 17: ...15 MN 753 Air Lift 1000 Notes...