Air Lift Air Lift 1000 60815, Руководство по установке

Страница: 9 / 16

7
MN-692
air lift 1000
13. Raise the axle or lower the vehicle body until the air springs lightly touch the upper
spring seat and lower spacers.
14. Check the tail pipe clearance and insure that it is at least 2-3 inches from the air spring.
If necessary, loosen the clamps and rotate or move to obtain additional clearance.
Reattach the shock absorbers if removed earlier in the installation.
DO NOT INFLATE AIR SPRINGS BEFORE READING THE MAINTENANCE AND
OPERATION SECTION.
15. Continue to “Completing the Installation.”
DUAL AIR LINE ROUTING
TO PREVENT AIR LINE FROM MELTING, KEEP IT AT LEAST 8” FROM ExHAUST
SYSTEM.
1. Select a location for the inflation valves in the rocker panel flange, or rear bumper,
assuring that each valve will be protected and accessible with an air hose.
2. Determine and cut an adequate length of air line to reach from the valve location to the
left side air spring.
LEAVE SUFFICIENT AIR LINE SLACK TO PREVENT ANY STRAIN ON FITTING DURING
AxLE MOTIONS.
3. Insert the air line through the spring seat and spacer.
4. Slide the air clamp onto the cut air line.
5. Push the air line onto the stem, covering all the barbed section (see fig. 7). With pliers
slide the air line clamp forward until it fully covers the barbed section.
6. Repeat process for the right side.
7. Drill a 5/16 “ hole for the inflating valves and mount as illustrated. The rubber washer is
for an outside weather seal (see fig. 9).
8. Route the air line along the control arm and frame to the inflation valve location and cut
off the excess.
9. Slide a clamp onto the air line and push the air line over the fitting, covering all the barbs.
With pliers slide the air line clamp forward until it fully covers the barbed section (see
fig. 10).
10. Raise the axle or lower body until the air springs lightly touch the upper spring seat and
lower spacers.
11. Check the tail pipe clearance and insure that it is at least 2-3 inches from the air springs.
If necessary, loosen the clamps and rotate or move to obtain additional clearance. If you
are installing this kit on a Honda Odyssey see page 6 for instruction on how to install
the heat shield. Reattach the shock absorbers if removed earlier in the installation.
DO NOT INFLATE AIR SPRINGS BEFORE READING THE MAINTENANCE AND
OPERATION SECTION.
COMPLETING THE INSTALLATION
1. Inflate the air springs to 35 PSI. Test for air leaks by applying a liquid solution of
1
/
5
dish
soap to
4
/
5
water to all valve cores, fittings and connections.
2. Lower the vehicle to the ground. Read Maintenance/Operation Tips for proper care of
your air springs.
3. Recheck air pressure after 24 hours. A 2-4 PSI loss after initial installation is normal. If
pressure has dropped more than 5 lbs, retest for leaks.
CAUTION
CAUTION
CAUTION
CAUTION