Air Lift Air Lift 1000 60815, Руководство по установке

Страница: 8 / 16

6
MN-692
air lift 1000
Installing the heat shield is only necessary on the Honda Odyssey.
11. To install the heat shield, bend the tabs on it to provide a ½” dead air space between
the exhaust pipe and the heat shield (fig. 11).
12. Attach the heat shield to the exhaust pipe using the clamps. Bend the heat shield for
maximum clearance to the air spring (fig. 11).
9. Drill a 5/16” hole for the inflation valve and mount as shown (fig. 9). The rubber washer
serves as an outside weather seal.
10. Slide the air line clamp over the air line. Push the air line onto the fitting covering all
barbs. Using pliers, slide the air line clamp forward until it fully covers the barbed section
(fig. 10).
fig. 10
Be sure to fully cover
the barbed section.
fig. 9
Vehicle body
or bumper
Air line
clamp
Hex nut
Rubber
washer
Lock
washer
Inflation
valve
Flat washer
Air line
Hex nut
Option 1
Option 2
7. Push the remaining air line over the last fitting on the tee and route it along the frame
to the desired inflation valve location. Attach the air line with plastic straps or wire.
8. Select a location for the inflation valve in the gas cap well, the trunk, rear bumper, fender
flange or behind the license plate, insuring that the valve will be protected and accessible
with an air hose (fig. 8).
fig. 8
Bend tabs
½” Dead air space
NOTE
fig. 11