Air Lift 88295, Руководство по установке

Страница: 9 / 20

7
MN-822
LoadLifter 5000 Ultimate
ATTACHING THE LOWER BRACKET
1. Secure the lower bracket to the axle using the axle straps (M), 3/8” flat washers (I), and
3/8” nyloc nuts (H) (fig. 7).
THE BRAKE LINE SITS UNDER THE BRACKET BETWEEN THE CARRIAGE BOLT AND
THE AXLE ON THE INSIDE OF THE RIGHT HAND UNIT . THE OUTSIDE CARRIAGE
BOLT GOES BETWEEN THE BRAKE LINE AND THE AXLE (FIG . 7) .
It may be necessary to re-position the brake line on the right and left hand sides to gain
clearance.
2 . Tighten the lock nuts evenly to 16 ft/lbs . Re-torque after 100 miles .
3 . Repeat for the opposite side .
INSTALLING THE HEAT SHIELD
1. Bend the tabs on the heat shield (G) to provide a ½” of space between the exhaust pipe
and the heat shield (fig. 8).
2. Attach the heat shield to the exhaust pipe using the provided clamps (fig. 9). Bend the
heat shield for maximum clearance to the air spring .
fig. 7
Brake line
Axle strap (M)
3/8” Flat washer (I)
3/8” Nyloc nut (H)
Lower bracket
The outside carriage
bolt should be between
the brake line and axle.
The inside carriage bolt
should be outside the
brake line and axle.
NOTE
CAUTION
fig. 8
fig. 9
Bend tabs.
Heat shield (G)
Exhaust