Air Lift 57365, Руководство по установке, Страница: 13 / 28

LoadLifter 5000 Series
MN-1052
11
INSTALLING THE ASSEMBLIES
1. Index a 3/8” carriage bolt (L) into the opening on the front of the driver’s side
assembly as shown (Fig. 21).
2. Drop the axle again to gain clearance to put the two assemblies into position on the
axle.
3. Set the left (driver’s) side assembly into position with the carriage bolt still in the slot
(previously installed). Set into place on the axle, making sure the back of the bracket
is “hooked” below the jounce bumper strike plate. Push the assembly forward while
lining up the carriage bolt with the existing hole in the front of the lower jounce
bumper strike plate (Figs. 22 & 23). Cap the carriage bolt with a 3/8” serrated lock
nut (N), but leave loose at this time.
fig. 21
fig. 22
L
fig. 23
L
N