Air Lift 57365, Руководство по установке, Страница: 10 / 28

LoadLifter 5000 Series
MN-1052
8
12. Center-punch the frame and drill a 1/4” hole (Fig. 13). Start a 5/16” self-tapping
screw (K) into the hole, making sure it is straight, and tighten it enough to form
the threads needed to set the screw (Fig. 13). Remove the screw once threads are
formed.
13. Set the bracket back in place on the frame and bolt into position using the
self-tapping screw previously set into the frame. Tighten the screw making sure
the washer head portion of the screw is flat to the bracket, and torque to 15 lb.-ft.
(20Nm).
14. Make sure the bracket is flat to the bottom of the frame, center punch and drill
through the frame with a 1/4” bit using the holes in the side of the flange as a guide
(Fig. 14).
15. Install two more self-tapping screws (K) in the side, making sure the flat head portion
of the bolt is flush to the bracket, and torque to 15 lb.-ft. (20Nm) (Fig. 15). Repeat for
the other side.
fig. 13
fig. 14
fig. 15
Driver’s side
bracket
shown
mounted in
place and
ready for the
air spring
assembly.
K
K