Aim FD400, Руководство пользователя

Страница: 20 / 24

Sharp objects
The FD400 can be equipped with nozzles and needles to dispense as
desired.
Caution should be taken when using these attachments, because they
can puncture your skin.
Define path to and from the dispensing path
Define path to and from the purge point
As the units can be used with nozzles care should be taken when defining
the movement for the robot ensuring the tip does not cause incidents.
Tool Speed / Elbow Speed: In the safety settings consider changing speeds to ensure
only full speed when dispensing and reduced speed when away from the path to
avoid needle injuries.
Tool Force / Elbow Force: Limit the maximum force exerted by the tool or elbow on
the environment.
It is recommended to set robot limitations in Installation > Safety > Robot Limits:
reduce limits to ensure greater safety so that the robot will stop dispensing if it exceeds
these limits.
Take care when inserting / removing / releasing the handle on the container as
the spring might release the container from the unit with great force. Hold on
tight.
Ensure the container is correctly fitted to unit before releasing the handle to
avoid it falling of the unit
Take care when attaching the container to the unit. If it is done while the unit is
on the robot be careful to not use too much force, to protect the robot.
Any change to the unit or in-correct assembly, such as removing o-rings or not
screwing the unit on correctly , may lead to accidents, failures or leaks.
Ensure that the orifice of the tip is suitable for the fluid to avoid pressure build
up.
The electronics box must not be opened or the warranty will be void.
SAFETY
CAUTION
Control path of tip
Limitations
17