Aim FD400, Руководство пользователя

Страница: 11 / 24

OPERATIONS GUIDE
Start up
In Installation > URCaps > Setup tab, select the Press&Hold to dispense button and
press until there is a steady flow through the dispenser.
After the unit has been paused or stopped, through flow should be tested and the tip
changed
Cleaning
We recommend filling the unit with a fluid cleanser and letting it run through the system.
It is also possible to disassemble the unit and clean the parts individually. Any part
containing electronics or motor must NOT be opened and cleaned.
"Purge Cycle"
The Purge Cycle, when activated, is a predefined cycle that ensures the fluid does not
settle in the unit. This can be useful in pauses, production breaks or at setup.
When the unit is positioned over the Purge Position the unit will dispense for 0,5
seconds every 5 minutes ensuring flow.
"Purge Position"
Place a container at this position to collect the fluid dispensed.
Use this position to purge the unit at cartridge refill, at pause or at end of shift.
This is an operator defined position which is where the robot will know it can dispense if
the Purge Cycle has been activated.
"Press & Hold to dispense"
When using a new cartridge or after a pause then it is recommended to purge the
system. Press & Hold the button to dispense fluid continuously. Use this to ensure even
flow in the unit.
"PullBack"
The PullBack function holds back the fluid to ensure more precise dispensing at the end
of the path. Use this to prevent fluid 'hanging' from the nozzle after dispensing along
thepath.
8
Pull back rod handle and lock it in place, then remove cartridge holder form unit
Pull out old cartridge and clean holder with a dry cloth before inserting new cartridge
In Installation > URCaps > Setup Tab: select Press&Hold to dispense button and
press until there is a steady flow through the dispenser.
If Empty: Remove cartridge from funnel
If not Empty:
After replacing with new cartridge:
Change of Cartridge