Installation-, Operating-, Maintenance-Manual, Spare Part List
BCR02
AGT-PSG GmbH & Co.KG
Errors and printing mistakes excepted
Page 7
Translation - Manual BCR02 Rev. 6/2016
Assembly and Installation
Installation Site
The main dimensions are shown at the dimensioned drawing of the sample gas cooler. The weight is
mentioned on the model identification plate.
Failure to install the sample gas cooler in the proper ambient conditions will affect the sample gas coolers
ability to condense refrigerant gas. This can cause higher loads on the compressor, loss of cooler
efficiency and performance, electrical component failure and cooler failure due to the following:
Compressor loss and electrical component failure. Failures of this type will affect warranty considerations.
The layout of the compact sample gas conditioner guarantees a problem-free integration into the analysis
systems.
Minimum installation requirements:
Select a clean dry area, free from dust, and protected from atmospheric disturbances. Avoid
direct solar radiation.
Minimum ambient tempe5°C, maximum ambient tempe45°C.
Specific humidity: 20-70%, non-condensing.
For the wall mounting, the wall has to be perfect vertical. The brackets must hold 4 times the
given weights. Only use the existing fastening points of the housing. The cooler has to be
mounted in perfect upright position.
Ensure unhindered cooling air circulation while installing the sample gas cooler. Do not install the
sample gas cooler directly over, under or beneath possible sources of heat.
CAUTION! Ambient conditions!
Do not install the cooler in areas of extreme dust and dirt or
in corrosive environment. The cooler is designed for indoor using, not for outdoor using.
CAUTION! Min. 80mm free space for ventilation and bleeding!
The required free space at
side- and top-plates for ventilation and bleeding the sample gas conditioner must be maintained
for smooth functioning.
We recommend a wall mounting of the device. For an operation in enclosed housings, such as
analytic cabinets, we recommend a suitable ventilation or air conditioning.
If your sample gas cooler is equipped with handles (mobile version), please use exclusively
these handles to lift or move the cooler. Otherwise the cooler is only to lift or move at its
bottom panel (1-2 persons needed). Handle with care. Heavy blows could cause irreparable
damage.
WARNING! Possible damage!
Handle with care. Heavy blows could cause irreparable
damage.
WARNING! Possible damage!
Protect the display during installation of the cooler or during
mounting work. The display is very fragile.
