AGROSE ATT-1000, Руководство пользователя

Страница: 28 / 38

24
16.3. LUBRICATION
The moving mechanical components must be lubricated to prevent wear and over
heating. This lubrication can be done with grease or oil: oil allows significantly higher
speeds, in general grease is used to lubricate bearings with a vertical or inclined axis as
it stays in the zone for longer.
NOTE: For all the pumps (in name of MERTSAN) using oil: 20W50
16.4. MULTIPLIER LUBRICATION
The viscosity is an essential characteristic of a lubricant oil and this is indicated by the
SAE (SOCIETY OFAUTO-MOTIVE ENGINEERS) classification of the oils for gearboxes
and differentials. Special additives improve the capacity of the oil to
maintain a lubricant film also at high pressures and temperatures. We
recommended using SAE 140 oil for the multiplier and disengaging boxes.
The quantity of oil is established by the level cap. A greater quantity of oil
doesn’t improve the conditions of lubrication and can cause overheating in
the box. Changing the oil protects the parts from the dangers associated
with wear and the presence of metallic particles that can be present,
especially in the first period of use. Were commend replacing the oil after
the first 50 working hours and then subsequently every 500 hours.
WARNING:
the oil used mustn’t be dispersed in the environment and must
be collected the relevant containers.
16.5. EXTRAORDINARY MAINTENANCE
At the end of a season of intense use, or every two years of normal use, it
is a good idea to have a specialized service technician perform a general
check on the machine.
We recommend having the normal AGROSE assistance service available
from our reseller perform any repairs or contact a specialized workshop.
During all of the repairs, in particular when welding, the machine and the
circuit must be clean of any residues of chemical product.
Also make sure the machine is stopped, connected to the tractor, and use
the relevant chocks to block the wheel still on the ground.
If you use a jack (manual or hydraulic) make sure you use a jack that is suitable for the frame
so it can’t
slip and put it in the right position. The jack must be placed under the main frame of the machine near the
wheel to change. Make sure the ground is compact: if necessary use wooden beams or other sufficiently
resistant material to broaden the supporting base of the jack.
17. STORAGE IN A WAREHOUSE AND TRANSPORTATION
The sprayer must be kept in a closed place away from excessive humidity and protected from frost.
Especially if electrical pressure regulators, electrical motors, a spraying computer or similar components
are fitted.
Before storing the machine, after you have washed it, apply a light coat of oil.
If the temperature might drop to below zero, drain any residual liquid or add roughly 0.5 L of normal
antifreeze for auto vehicles.
17.1. PUTTING BACK INTO SERVICE AFTER WINTER LAYUP
Before using the machine again after a long period of inactivity you should perform some general checks,
and drain any antifreeze.
Never start the shaft of the pump if you think there may by ice inside. To check this, make sure you can
turn the shaft by hand without connecting it to the tractor.
After you have connected the machine to the tractor following the instructions
in the present user’s
handbook and in the enclosures of the pump, pressure regulator and accessories.