AGROSE ATT-1000, Руководство пользователя

Страница: 16 / 38

12
4.3. CARDAN SHAFT

In some models this is supplied on request.

The cardan shaft must bear the CE mark.

It must always have its own instructions that must be followed
scrupulously and it should come with a cover bearing the mark,
integrated in every part.

You should have previously checked the length to avoid:

If it is too long, DANGEROUS THRUST ON THE PUMP SHAFT

If too short, the POSSIBILITY OF DANGEROUS BREAKAGES

THE MINIMUM OVERLAP OFTHE TWO TELESCOPICTUBES MUST NEVER
BELESS THAN 1/3 OF THELENGTH OF THE TUBES.
Adjusti
N
g the PTO shaft male and female tubes;
Position the tractor until its rear tire gets close to the
sprayer’s tongue.
Connect the PTO shaft.
Adjust the male and female tubes lengths (recommended overlap: 1.96 in).
The power that can be transmitted by the cardan shaft must be at least equal
to that required to run the atomizer.
These power ratings are indicated in
Tables N°
3A-3B-(pages 26-27)
a) Hook any safety chains to solid anchor points
b)
Check that the button or ringnut “E” (PICTURE. 6) is correctly engaged and blocked both on the
pump side and on the tractor side.
c)
Don’t exceed an inclination of 30° in any direction for any reason
d) With the machine stopped, periodically grease the spiders and the pipes, keeping the connecting zone
particularly clean
e) Avoid letting the end of the cardan shaft come into contact with the ground with the machine stopped;
use the relevant support on some versions for this, if your machine has no support, hook the external
safety chain to apart of the frame of the machine (ex. control unit support).
PICTURE 5
PICTURE 6
PICTURE 7
T
P
D