9
aTTaCH THe Leaf Rake TO THe
BULkHead
STeP 13:
(See fIGURe 13)
•
Lay the bulkhead with the pusher wall assemblies flat.
•
Place the rake brace (13) on the leaf rake (9), aligned
to the top of the leaf rake.
•
Attach the leaf rake (9) and rake brace (13) to the
bottom of the bulkhead (12) using two hex bolts (M),
and hex nuts (H) and tighten.
•
Add a second hex nut (H) to each hex bolt and tighten.
H
9
13
12
M
TOP
BOTTOM
fIGURe 13
aTTaCH THe PIvOT aSSeMBLY TO THe
BULkHead
STeP 14:
(See fIGURe 14)
•
While holding the pusher wall assembly up to
the blade mount assembly (5), insert the pivot shaft
(14) through the two sets of pivot brackets (4) and the
holes in the bulkhead (12).
NOTe:
The holes to use in the bulkhead are determined
by your tractor height.
•
Make sure the leaf rakes are not resting on the ground.
If they are, then raise the pivot shaft (14) up one hole
in the bulkhead (12).
•
Secure each end of the pivot shaft (14) using a washer
(O) and a hair cotter pin (P).
P
P
O
O
14
5
4
12
fIGURe 14
