19
ELECTRIC ATTACHMENT CLUTCHES
FIGURE 42
FIGURE 43
VIEW OF BOTTOM
STEP 43: (SEE FIGURE 43)
• Attach the two rear pulley frame brackets to the inside
of the clutch/idler assembly using two 5/16" x 1" hex
bolts, eight 5/16" washers and two 5/16" nylock nuts
for each bracket.
• Attach the two front pulley frame brackets to the inside
of the clutch/idler assembly using two 5/16" x 3/4" hex
bolts, 5/16" washers and 5/16" nylock nuts for each
bracket.
STEP 44: (SEE TABLE 2)
•
Two different length drive belts are included with
your snow thrower. Use the table below to select
the correct drive belt for your type tractor. The part
number is printed on the outside of the belt .
•
Set aside the belt that is not for your tractor to avoid
accidentally using it.
55" BELT (PART #46989)
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
56" BELT (PART #48138)
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
(LT) Lawn Tractor
48"
Electric
(LT) Lawn Tractor
38", 42", 46"
Electric
TABLE 2
STEP 41: (SEE FIGURE 41)
• Turn the clutch idler assembly upside down.
• Hook the long end of the spring (onto the end of the
bolt that extends through the nut on the bottom of the
upper idler arm. Install a 3/8" hex lock nut onto the bolt,
leaving enough space for the spring to pivot.
FIGURE 41
STEP 42: (SEE FIGURE 42)
• Insert tensioning chains through the holes shown and
attach to the springs on the upper and lower idler arms.
• Install a 3/32" hairpin cotter in the 5th link of the chain
attached to the upper idler arm.
• Install a 3/32" hairpin cotter in the 4th link of the chain
attached to the lower idler arm.
3/8" HEX
LOCK NUT
SPRING
ATTACH
LONG
END OF
SPRING
HERE
TENSIONING CHAIN
(lower idler arm)
TENSIONING CHAIN
(upper idler arm)
3/32" HAIRPIN
COTTER IN
5th LINK
3/32" HAIRPIN COTTER
IN 4th LINK
5/16" x 3/4" HEX BOLT
5/16" x 1"
HEX BOLT
5/16" NYLOCK NUT
5/16"
WASHER
(4) 5/16" WASHERS
