4
ASSEMBLY INSTRUCTIONS
1. Install a 5/16-18 x 2-3/4" hex bolt (17) and a 5/16"
jam nut (25) in each bag arm channel.
FIGURE 1
17
4
25
TOOLS REQUIRED
(2)
1/2" Wrenches
(2)
7/16" Wrenches
(1)
Pliers
(1)
Hammer
2. Slide the bag arm channels (4) into the sweeper
HOUSINGASSHOWNINÚGURE3ECURETHEMTOTHE
sweeper housing with a 5/16-18 x 2-1/2" hex bolt (15)
and 5/16" nylock nut (21). Tighten bolt until snug.
Do
not overtighten.
FIGURE 2
15
4
21
3. Secure each bag arm channel to the side of the
sweeper housing with a plastic wing nut (31) installed
ONTOTHEBOLTASSEMBLEDINSTEP3EEÚGURE
4. Insert a pivot rod retainer (30) down into the end of
EACHBAGARMCHANNEL3EEÚGURE
5. Install a compression spring (32) into the bottom of
each of the pivot rod retainers to secure them to the
BAGARMCHANNELS3EEÚGURE
FIGURE 3
31
30
32
6. Attach the drawbar (14) to the sweeper by fastening
a drawbar bracket (8) above and below the drawbar
using two washers (63), three 5/16" x 2-1/2" hex bolts
ANDNYLOCKNUTS 3EEÚGURE
FIGURE 4
8
15
14
21
8
63
63
