Agilent Technologies N5230AU-974, Установочная инструкция

Страница: 21 / 30

Installation Note N5230-90022 21
Install the New Test Set Deck Front Panel
Refer to Figure 14 for this procedure. New parts are listed in Table 1 on page 4 .
1. Place the new test set deck front panel, with the LED board and both new couplers
attached, onto the test set deck as shown.
2. Using a T-10 TORX driver, loosely reinstall the eight screws (items
❶
through
❽
) to secure
the front panel to the test set deck. Once all screws have been loosely installed, torque each
of the eight screws to 9 in-lbs in the order indicated (
❶
through
❽
). This is important to
ensure proper alignment.
3. Reconnect the wrapped wire cable (item
①
) to the front-panel LED board.
Figure 14 Test Set Deck Front Panel Installation