Chapter 4
71
Operation
Operating the N5102A Module in Input Mode
Operating the N5102A Module in Input Mode
This section shows how to set the parameters for the N5102A module using the signal generator UI in the
input direction. Each procedure contains a figure that shows the softkey menu structure for the interface
module function being performed.
Refer to
“Connecting the Clock Source and the Device Under Test” on page 60
and configure the test setup.
Accessing the N5102A Module User Interface
All parameters for the N5102A module are set with softkeys on the ESG/PSG signal generator.
Press
Aux Fctn
>
N5102A Interface
.
This accesses the UI (first-level softkey menu shown in
Figure 4-15
) that is used to configure the digital
signal interface module. Notice the graphic, in the ESG/PSG display, showing a setup where the N5102A
module is generating its own internal clock signal. This graphic changes to reflect the current clock source
selection.
Figure 4-15
First-Level Softkey Menu
Selecting the Input Direction
If both Option 003 (output mode) and Option 004 (input mode) are installed, you must select the input
direction.
Press
Data Setup
>
Direction Input Output
to Input and press
Return
.
Line is grayed out until the N5102A module interface is turned on
Internal clock going to the DUT
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com