Replacement Procedures
2
Quiet Cover MS Service Manual
27
•
Ferrite.
Slide the wires of the ferrite into the wire
holder attached to the center of the LED holder. Then,
slide the ferrite into the holder so it is held firmly in
place next to the LED holder.
•
LEDs.
Connect the + and – wires (marked
GLED +/–
and
RLED +/–
) to the green and red LEDs, respectively.
•
On/off switch.
Connect the
SW-2
wire to the top
switch connector tab and the
SW-1
wire to the bottom
connector tab.
5
Verify that the oil tray does not pinch any of the wires
when sliding the oil tray in and out of the Quiet Cover
MS.
