Agilent Technologies G6011A Quiet Cover MS, Руководство по обслуживанию

Страница: 22 / 30

22 Quiet Cover MS Service Manual
2
Replacement Procedures
Replacing the On/Off Switch
Required tools
None
Procedure
1
Perform the steps under “Preparing the Quiet Cover MS
for Repair” on page 14.
2 Inside the cabinet remove the two wires
SW-1
and
SW-2
from the on/off switch (see Figure 13 ).
3
Squeeze the latches on the back of the switch and push it
out through the front of the Quiet Cover MS.
4 Toggle the new switch so the red does not show.
5 With the raised end of the switch at the top, push the
new switch in place. (The two wiring connectors will be
towards the bottom of the switch, see
Figure 13 .)
6 Connect the
SW-2
wire from the wiring harness to the top
connector of the switch and the SW-1 wire to the bottom
connector.
Figure 13 Wires to remove from the on/off switch (G6011A shown.)
Remove wires