Agilent Technologies 929-0022, Инструкция по эксплуатации

Страница: 22 / 36

TECHNICAL INFORMATION
SUBLIMATION CONTROLLER DESCRIPTION
The Sublimation Controller base is available in two
versions which differ only in the factory set input
voltage.
•
Model 929-0022 set for 120 Vac 60 Hz
•
Model 929-0023 set for 220 Vac 50 Hz
Sublimation Controller
It consist of various boards. The following figure
shows the minimum configuration.
Sublimation Controller boards (Top view)
1) Dc power supply board: it contains the line
voltage change over and the EMI filter.
The ac input voltage is rectified and the needed
DC output voltages are generated.
2) Microprocessor boards (located on front panel: it
is based on a single chip microprocessor with a
large input/output capability. It manages
commands coming from the front panel
keyboard and from the various cards and drives
the front panel display and all output card
function.
3) Display and front panel keyboard: it contains the
functional push buttons, the LEDs indicating the
operating filament and the active mode of
operation and the LCD display.
NOTE
Leave at least 30 mm (1.2 inches) of free air
circulation on top and bottom of the unit for an
efficient cooling of the unit. Blind the unused slots
on rear panel with the provided covers.
SUBLIMATION CONTROLLER SPECIFICATION
Input:
−
Voltage:
(selectable at
the rear of
the case)
−
90 to 110 Vac - 1 phase
(use setting 100 Vac)
−
110 to 130 Vac - 1 phase
(use setting 120 Vac)
−
190 to 230 Vac - 1 phase
(use setting 220 Vac)
−
230 to 265 Vac - 1 phase
(use setting 240 Vac)
−
Frequency:
−
Power:
Fuse:
47 to 63 Hz
660 W active power
(maximum)
800 VA apparent power
(maximum, see note)
6.3 A (for 220-240 Vac
setting) slow blow (qty. 2)
10 A (for 100-120 Vac
setting) slow blow (qty. 2)
Operating:
−
Temperature
−
Humidity
0 to + 45 °C
90% maximum non
condensing humidity
Radio
interference
suppression Conforms to:
EN55011 class A group 1
IEC 1000-4/2/3/4
Safety
requirements Conforms to:
EN 61010 and EN 60204
Installation
category II
Pollution degree 2
Cables Mains (3 meters long, 3
wires, Ø 0.75 mm
2
)
Weight 12 Kg
NOTE
When the controller is powered by means of a
transformer, the transformer power must be at least
1500 VA to avoid a distortion of the power
waveform.
17 87-900-077-01(D)