42
30549 R1
Important
Do not turn winch handle counter-clockwise, except when lowering auger, or severe damage to
winch will occur.
Note
Winch must have clicking sound when raising auger. If clicking sound stops, retain grip on handle, lower
auger fully, and repair ratchet.
5.2. Placement Procedure
1. Move the auger into working position slowly, making sure that all persons are clear of the hazard zone (see
). DO NOT UNHITCH AND ATTEMPT TO MOVE THE AUGER BY HAND.
Important
When positioning the MK/HX auger, the PTO driveline must be disconnected from the tractor and
placed in the transport saddle to prevent damage to auger and PTO driveline (see
).
2. Once auger is in position, wheels should be chocked on both sides as well as applying the park brake on
tractor (or chocking its wheels) to prevent movement during operation.
3. Fully lower hopper to the ground and remove lift cable from the hopper.
4. See
Section 6.7 – Lowering Procedure on page 47
for correct lowering procedure.
Never attempt to increase height of auger by positioning wheels on lumber, blocks, or by any
other means. To do so will result in damage to equipment and/or personal injury.
Note
If auger wheels are partially or fully buried in snow or grain, do not attempt to move auger until snow
or grain has been cleared away from auger wheels. Failure to heed may cause damage to auger and/or
serious injury.
Do not use auger as a hoist to raise any object regardless of weight. This will create an unsafe
condition and will void warranty.
MK/HX 10-36 – SWING-AWAY GRAIN AUGER
