Model 5400 COLLECT
an
DRAIN
®
Owner’s Manual
4
INSTALLATION INSTRUCTIONS
Unpacking:
Unpack the COLLECT
1.
an
DRAIN
®
M5400 unit and carefully inspect for any
damages from shipping.
Verify box contents:
2.
COLLECT
•
an
DRAIN
®
M5400 unit
Four (4) Rubber Mounting Washers
•
Two (2) Door Keys
•
Electrical Wiring Schematic
•
M5400 System Drawing
•
Sprinkler System Preparation:
If installing in a new system, proceed to Mounting Instructions below, otherwise
continue with Preparation Instructions.
If adding additional installations, see NFPA 13 Chapters 24 and 26, and NFPA 25
Chapter 14.
Isolate the zone where the COLLECT
1.
an
DRAIN
®
will be installed.
Relieve air pressure from the branch line.
2.
Remove the existing auxiliary drain.
3.
Mounting:
Use the four mounting tabs (3/8” holes x 4) to install the M5400A to a wall or other
secure structure. If wall is uneven, use bushings or stand-offs to prevent cabinet
from bending when mounted.
Place the rubber washers behind the mounting
1.
tabs to hold the M5400 off of the wall. Select
fasteners suitable for attachment and capable
of supporting the 50 lb. weight of the M5400.
Connect to the 1” NPT Supply Pipe in accor-
2.
dance with NFPA 13 (8.16.2.5 and 8.16.2.5.3) in
regards to low-point drain installations.
Confirm that the Supply Valve (upper valve) is in
3.
the open position (vertical) and ready to collect
condensation, the Drain Valve (lower valve) is
in the closed position (horizontal), and the pipe
cap is tight.
