Agelkom CAP04-V Manual
3
Touch (Down Limit) Adjustment:
After all adjustment was finished, you can start to adjust Down Limit potentiometer, adjust
this multiturn trimmer potentiometer (turn CCW) until TOUCH LED is OFF Afterwards,
close the sensor ring until it touches the plate or insert paper between sensor ring and plate
(cutting material). Turn CW until TOUCH LED is ON
APPLICATION:
During plasma cutting, sensor ring and plasma torch are in the same height. This will allow
to use TOUCH output as a collision detection means. If any fault occurs, the UP output
activate automatically.
During thick plate cutting, dross may touch the sensor ring and the torch head lifted. To
avoid this situation correct your cutting parameters for less dross.
CAP04-V can be used with voltage controlled Height Control System. The two systems are
OR’ed.
67mm approx
.