AGA R3 110-4i, Руководство пользователя и инструкции по установке

Страница: 47 / 56

43
24. Installation and Levelling
1. NOTE : Care must be taken not to trap mains cables ( Fig.
24.1 ).
2.
When removing appliance from the pallet, the front
stability feet can be raised with a spanner to allow
appliance to be slid from transit pallet (
Fig. 24.2
).
3. Slide cooker off transit pallet.
4.
Appliance can now be pushed back on its wheels into
desired position.
NOTE
: Care must be taken not to trap
mains cable.
5. Levelling of appliance - Use 12mm socket to adjust
wheel mechanism for FINE adjustment on both sides at
rear of the appliance ( Fig. 24.3 ).
6.
Using a 13mm open end spanner, feet can be adjusted
at front to make
FINE
adjustments to the front of the
appliance and to provide a brake for the wheels (
Fig.
24.3
).
7. Turning the bolt clockwise will lower the wheel thus
increasing height of the cooker ( Fig. 24.3 ).
8.
Anti-clockwise lifts the wheels and lowers the cooker
(
Fig. 24.3
).
9. Fit the magnetic plinth ( Fig. 24.4 ) and sides.
10. Resting Plate Adjustment
- Resting plates have
adjuster screw feet for setting of height and to improve
stability (
Fig. 24.5
).
DESN 517645
Fig. 24.1
Fig. 24.2
MAINS CABLE
STABILITY FOOT
USE A 12MM OPEN END
SPANNER TO MAKE FINE
ADJUSTMENT.
DESN 516895
DESN 517690
DESN 517691
Fig. 24.3
Fig. 24.4
Fig. 24.5
FRONT PLINTH
COVER FITS OVER
SIDE SKIRTS
MAKE SURE SIDE PLINTH
SKIRTS ARE LOCATED IN
FRONT GUIDE BRACKET
DESN 517647