70
4.
If adjusting Port A, a Warning message will appear. Press
the Green Check Mark to accept it or the Red X to cancel.
5.
Use the Gray Up/Down Arrows or directly select the
desired Baud Rate.
6.
Press the Green Check Mark to accept changes or the press
the Red X to cancel.
PORT B MESSAGE
The procedure to enable and edit NMEA messages for Port B are
identical as the steps described in the Port A section. Refer to the
Port A Messages section for more information.
PORT B CONFIGURATION
The procedure to set the baud rate for Port B is identical as the
steps described for Port A except where noted. Refer to “Port A Configuration” on page 134 for more information.
CONNECTIONS TAB MENU OPERATIONS
The Connections tab enables the operator to configure and
monitor the cell modem, WiFi, and external devices connections
that the GeoSteer system must use to communicate.
To access the Connections tab, refer to your Display Operator’s
Manual for instructions on accessing the AutoSteer Setup
screens. Once there, press the Connections tab.
The buttons that can be available in the Connections tab are as
follows and are explained in more detail in this chapter:
Cell Modem
—This enables the operator to view information
about the cell modem connection and manage various
configuration settings. The screens and options available for this
button will change depending on the type of cell modem installed and the location the system is at.
External Radio
—This enables the operator to configure Serial Port A to communicate with an external 3rd party device.
WiFi
—Allows the operator to enable or disable the WiFi on the GeoSteer system. This feature is not available on all models.
CELL MODEM
The options available and the information shown in the Cell Modem screen will be different depending on if the GeoSteer
system has a CDMA modem (primarily for North America) or a GSM modem (rest of the world).
