afx light 16-2675, Инструкция по эксплуатации

Страница: 4 / 20

© Copyright LOTRONIC 2019 PARCOB150WH-MKIII Page 4
Addressing
The control board allows you to assign the DMX starting address,
Note; it’s necessary to insert the XLR termination plug (with 120ohm) in the last device in the link in order to ensure proper
transmission on the DMX data link.
CONTROL PANEL
The control panel offers several features: you can simple set the starting address, run the pre-programmed program or make a
reset.
•
The main menu is accessed by pressing the Mode/Esc-button.
•
Browse through the submenu by pressing Up or Down.
•
Press the Enter-button in order to select the desired menu. You can change the selection by pressing Up or Down. Confirm
every selection by pressing the Enter button.
•
You can leave every mode by pressing the Mode/Esc-button.
The functions provided are described in the following setting.
MENU MAP
The device has two operation modes: It can be operated in manual or DMX mode.
When in Master/Slave Mode, only one unit in a series chain can be set as the master.
STAT ST.00 Adjust strobe effect from 0~20
A.000 Adjust cold white from 0~255
B.000 Adjust warm white from 0~255
RUN
DMX and SLAV mode for selection
DMX Adjust DMX value from 001 to 512
TEMP
CURR show current fixture temperature
FAN Current setting temperature 30-55, default setting 40
Master/slave mode (auto-running, sound control)
This mode will allow you to link up 32 units together without a controller. Use standard DMX cables to daisy chain your units
together via the DMX connector on the rear of the unit.
DMX-protocol
Channel Value Function
1
0-255
Dimmer
0-100% dimmer
2
0-255
Cold white
0-100%
3
0-255
Warm white
0-100%