© Copyright LOTRONIC 2019 PARCOB150WH-MKIII
Page 2
Thank you for having chosen our
AFX LIGHT LED PROJECTOR.
For your own safety, please read this user manual carefully
before installing the device.
SAFETY INTRODUCTION
•
If the device has been exposed to temperature changes due to environmental changes, do not switch it on immediately.
The arising condensation could damage the device. Leave the device switched off until it has reached room temperature.
•
It is essential that the device is earthed. A qualified person must carry out the electric connection.
•
Make sure that the available voltage is not higher than stated at the end of this manual.
•
Make sure the power cord is never crimped or damaged. If it is damaged, ask your dealer or authorized agent to replace
the power cord.
•
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power cord by plug.
Never pull out the plug by tugging the power cord.
•
DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
•
Due to the magnifying type lens, please keep the lens out of contact with direct us. Direct we can cause heat to build up
inside of the unit, which will seriously damage unit.
•
Be very careful during installation. Since you will be working with a dangerous voltage you can suffer a life-threatening
electric shock when touching live wired.
•
Never look directly into the light source, as sensitive persons may suffer an epileptic shock.
•
Please be aware that damages caused by manual modifications to the device are not subject to warranty. Keep away from
children and non-professionals.
•
The light doesn’t include any spare parts for repair, please check if all the parts are well installed and screws are fitted
tightly before operating. Do not use the light when the cover is open.
•
This device is only allowed to be operated with an alternating current of max. 100-240VAC/50-60Hz and was designed for
indoor use only.
•
This device is designed for permanent operation. Consistent operation will ensure that the device will serve you for a long
time without defects.
•
Do not shake the device. Avoid brute force when installing or operating it.
•
Operate the device only after having familiarized yourself with its functions. Do not permit operation by person not
qualified for operating the device. Most damages are the result of unprofessional operation.
•
Please use the original packaging if the device is to be transported.
•
For safety reasons, please be aware that all modifications on the device are forbidden. Furthermore, any other operation
may lead to short-circuit, burns, electric shock, lamp explosion, crash, etc. If this device will be operated in any way
different to the one described in this manual, the product may suffer damages and the guarantee becomes void.
Power Supply and Signal Cable Connection
1. Mains Power connection
The exclusive plug should be used between the connection of unit and power. Please ensure that the rated voltage and
frequency are accordance with the power supply. The required input voltage and frequency are: 100-240Vac – 50/60Hz
We suggest that every light has an independent switch so that you can turn on or turn off the light randomly.
Note: the ground wire (yellow/green double-color wire) must be safely connected, the electrical installation must be in
accordance with the related standards
CAUTION
: When installing the device, make sure there is no highly inflammable material within a distance of min.1m!
GB
Содержание 16-2675
Страница 20: ...Copyright LOTRONIC 2019...
