AFINIA LABEL DLP-2000, Руководство пользователя, Страница: 18 / 43

18
Using the splicing table
 When the current roll of media is finished, stop the DLP-2000 or the loop sensor will stop the
machine when it sees no media. Push the Emergency Stop button.

Load the new roll of media into the printer or unwind mandrel, making sure the new roll is in
the same position as the previous roll. Enter the new roll of media into the splicing table and
align it with the previous media.

Lower and lock the top section of the splicing table. Using a sharp knife, cut through both pieces
of media, in the slot on the splicing table.

Using tape, join the underside of the new media to the underside of the previous roll, making
sure to align them as perfectly as possible. Undo and lift the top section of the splicing table,
remove the unwanted cut pieces of media and place another piece of tape across the top of the
media at the join. If laminate is being applied, the top tape is not required.

Using scissors or a sharp knife, cut the excess tape on each side of the media, as close to the
media as possible. Release the Emergency stop and press the reset button. You are now ready
to begin running a job.
The splicing table enables the user to join rolls of media together neatly and correctly, to
allow smooth passage through the die cutting, stripping and slitting processes. Follow
the instructions below on the use of the DLP-2000 splicing table.