SERVICE PROGRAM MODE
26 April, 2002
5-2
Accessing the Required Program
Use the “Up/Down arrow” keys to scroll through the menu listing.
1. Service: Controller service modes
2. Engine: Engine service modes
3. End: Exit service mode
To select an item, press the right-arrow key. Then the sub-menu will appear.
Scroll through the sub menu items using the “Up/Down arrow”keys.
To go back to a higher level, press the “left-arrow”key.
Inputting a Value or Setting for a Service Program
Enter the required program mode as explained above. The setting appearing on
the display is the current setting.
Select the required setting using the “Up/Down arrow” keys, then press the “right-
arrow” key. The previous value remains if the “right-arrow” key is not pressed.
Exiting Service Mode
NOTE:
When you exit the service mode, the printer automatically reboots.
Select “3. End” from the service mode main menu. After the following message has
appeared, press the “right-arrow” key.
NOTE:
If the settings of SP modes 5-993-013 to 015 are changed, these changes
will affect the next line position adjustment.
System Reboot
Execute?
G082S913.WMF
