Afar NX-2E1, Руководство оператора

Страница: 48 / 75

NetCrossing Gateway NX-2E1/T1 Operator’s Manual
4-14
community=<string>
Any string of up to 9 characters. For SNMP requests the “community” field in the request
packet from this IP address must match this parameter. For a Telnet session the username
entered when initiating the session from this IP address must match this string. If this
parameter is not specified it defaults to “public”. Note that you must always enter the
“manager” IP address in the same command line that sets the “community” value.
access=g or gs or gst or gt
SNMP access type authorized for this IP manager. Specify as any combination of three letters:
g (get), s (set) and t(trap). If this parameter is not specified it defaults to “get”. Note that you
must always enter the “manager” IP address in the same command line that sets the “access”
value.
authentication-traps=0 or 1
Specifies whether an “authentication trap” should be generated if a SNMP request is received
that can not be honored (due to invalid IP address, community or access fields). When enabled,
all IP managers that have “trap” access will receive this trap.
delete=1..4
Allows deleting one entry in the SNMP table. The number 1..4 refer to the entry number as
listed in the “display configuration” report.
Example:
> snmp manager=207.154.90.81 com=support access=gst
4.6 Installation and Monitoring Commands
show-table
table=status or gateways or ethernet or econsole or ip-stack
format=counts or times
clear=1 or 0
This command displays various tables in different formats as described below:
status table
This contains miscellaneous information including:
•
System start time and current time
•
Serial link status, peer, maximum jitter encountered, number of errors and time of last
error.
•
Serial port speed, packet generation rate and packet size.