54
17. If installing a choke servo use the provided
mounting tray and hardware shown below. Fol-
lowing same installation steps used for installing
throttle servo install choke servo.
16. Attach the throttle pushrod with the 4/40 ball
links and secure. Power up the receiver and
throttle servo and adjust pushrod for proper op-
eration. Ensure the servo or rod does not bind or
jam at closed or full open positions.
18.
If a manual choke will be installed gather the
choke pushrod, ball link, wheel collar and
nylon ties as shown. Wheel collar and ties are
Not Supplied.
19. We recommend installing the carburetor choke
pushrod as shown. Use nylon ties to provide
support and holding friction for the choke push-
rod. Place silicon fuel tubing over the wire
pushrod to prevent damage from vibration and
provide holding friction. Place a wheel collar on
the end of the pushrod to provide a finger grip.
