29
Elevator Servo Installation
1.
The elevators have been pre-hinged and
glued
to the stabs and are ready for flight. No other
steps are necessary for hinging.
Gather the following items for the stab/elevator
assembly,
◊
2 - Elevator servos
◊
2 - 1 1/4” Servo arms
◊
2 - 36” servo extensions
◊
2 - Aeroworks safety clips
◊
8 - Servo mounting screws
STAB AND ELEVATOR ASSEMBLY
IMPORTANT
2. Stabs have been built to have adjustable inci-
dence, The front L bracket mounting tab has
been made to slide up to provide 1 degree of
positive incidence. I plywood spacer has been
installed in the bottom of the L bracket mount.
Aligning the stab L bracket with this plywood
spacer will set the stab to zero degrees, this is
the recommended starting location and is recom-
mended for the first flight.
3. Install the right elevator servo as shown below.
The output shaft will face forward on the right
elevator assembly.
4. Install the left elevator servo as shown below.
The output shaft will face rearward on the left
elevator assembly.
Nose
Tail