27
20. Attach servo arm to servo as shown below.
21. Plug the rudder servo into the rudder channel of
the receiver and power up. Turn on transmitter
to center rudder servo. Ensure servo trim and
sub trims are centered.
Note:
On metal geared servos use blue Loctite for
all Servo arm mounting screws.
22. Tape the rudder balance tab to the top leading
edge of the vertical fin in the neutral position as
shown. This ensures the rudder is straight when
the cables are attached.
23. Attach the ball link to the rudder control horn as
shown below. Follow the same steps as shown in
the previous pages to install the ball link to the
pull pull cable.
