42
11. Solder the threaded coupler to the throttle
pushrod wire.
Note:
Lightly sand end of rod for best bond.
12. Attach the throttle pushrod with the 4/40 ball
links and secure. Power up the receiver and
throttle servo and adjust pushrod for proper op-
eration. Ensure the servo or rod does not bind or
jam at closed or full open positions.
13. Use thick CA on the back of the throttle servo
mounting servos as shown. This will prevent the
servo screws from loosening in flight.
14. A none soldering method of attaching throttle
pushrod is shown in the following steps.
Hardware for this method is
not supplied
.
Gather (2) 4-40 ball links, (1) brass spacer,
and 4-40 all thread.
