Aerotech PRO22SL, Руководство по оборудованию

Страница: 19 / 60

Chapter 2: Installation
WARNING : PRO225SL/SLE installation must be in accordance to instructions provided by
this manual and any accompanying documentation. Failure to follow these instructions
could result in injury or damage to the equipment.
2.1. Unpacking and Handling the Stage
WARNING : HEAVY! It is the responsibility of the customer to safely and carefully lift and
move the PRO225SL/SLE.
l
Refer to Section 1.3. for stage mass specifications. Do not attempt to lift heavy loads
single handed.
l
Use care when you move the PRO225SL/SLE or you could negatively affect the per-
formance of it.
l
Lift this product only by the base.
l
Use a cart, dolly, or similar device to move the stage to a new location.
l
For multi-axis assemblies, always lift the system by the lower axis.
l
Do not use the cables or the connectors to lift or move this product.
l
Make sure that all moving parts are secure before you move the PRO225SL/SLE. Unse-
cured moving parts could shift and cause injury or damage to the equipment.
Carefully remove the stage from its protective shipping container. Gently set the stage on a smooth, flat,
and clean surface. Use compressed nitrogen or clean, dry, oil-free air to remove any dust or debris that
has collected during shipping.
Before you operate the stage, let it stabilize at room temperature for at least 12 hours. This will ensure
that all of the alignments, preloads, and tolerances are the same as they were when they were tested at
Aerotech.
Each stage has a label listing the system part number and serial number. These numbers contain
information necessary for maintenance or system hardware and software updates. Locate this label and
record the information for later reference.
PRO225SL/SLE Hardware Manual Chapter 2: Installation
www.aerotech.com 19