Aerotech Automation1 XL2e, Руководство по оборудованию

Страница: 29 / 92

2.2. Motor Power Output Connector
DANGER : Before you do maintenance to the equipment, disconnect the electrical
power. Wait at least one (1) minute after removing the power supply before doing
maintenance or an inspection. Otherwise, there is the danger of electric shock.
The drive can be used to drive the following motor types:
l
Brushless (refer to Section 2.2.1. )
l
DC Brush (refer to Section 2.2.2. )
l
Stepper (refer to Section 2.2.3. )
For a complete list of electrical specifications, refer to Section 1.1.
IMPORTANT : Refer to local electrical safety requirements to correctly size external
system wires.
The 8-pin terminal block style motor output connector is located on the front panel. The pinout for
this connector is shown in
Table 2-5 .
Table 2-5: Motor Power Output Connector Pinout
Pin Description
Recommended
Wire Size Connector
Earth Ground to Motor
0.5 mm
2
(#20 AWG)
A
Brushless Phase A Motor Lead
DC Brush +
Stepper
0.5 mm
2
(#20 AWG)
B
Brushless Phase B Motor Lead
Stepper
0.5 mm 2 (#20 AWG)
C
Brushless Phase C Motor Lead
DC Brush -
Stepper Return
0.5 mm
2
(#20 AWG)
Table 2-6: Mating Connector Part Numbers for the Motor Power Output Connector
Type
Aerotech
P/N
Third Party
P/N
Screw
Torque: Nm
Wire Size:
mm 2 [AWG]
8-Pin Terminal Block ECK02625 Phoenix 1839694 0.22 - 0.25 1.5 - 0.08 [16 - 28]
XL2e Hardware Manual 2.2. Motor Power Output Connector
www.aerotech.com 29