Aeroqual Series 300, Руководство пользователя

Страница: 9 / 56

Charging and Discharging the Batteries
Ni-MH batteries
Ni-MH batteries must be fully charged prior to first-time use. A new Ni-MH
battery's full performance is achieved only after a number of complete
charge and discharge cycles. A fully charged battery will run for approxi-
mately 4-6 hours depending on the sensor head being used.
Charging Instructions
With the adaptor plugged in allow 15 hours for the battery to fully charge.
Note 1:

During charging the battery symbol on the display flashes slowly.

The battery can be charged with the sensor head installed or removed
from the base. (Remember to switch off the monitor before removing
the sensor head).

Unplugging the main power will reset the above charging conditions.

The batteries can be charged and discharged many times but will even-
tually wear out. When the operating time is noticeably shorter than nor-
mal, it is time to replace the batteries.

It is not necessary to fully discharge the batteries. When not using the
Series 300, 305, 500 or 505 Monitor as a portable unit, always plug in
the mains adaptor to recharge the batteries.

If left unused a fully charged battery will discharge itself over time.
Note 2:
If you have difficulty charging the battery, either:
A)
Replace the battery
B) Contact Aeroqual with the software version number
(see section 3.3 to locate the version number.)
Additional Information for Lithium Polymer Batteries
A new battery's full performance is achieved only after a number of com-
plete charge and discharge cycles. A fully charged battery will run for ap-
proximately 10 hours depending on the sensor head being used.
Charging Instructions

With the adaptor plugged in allow 3 hours for the battery to fully charge.

There is no battery symbol on the display when using a lithium battery.

The battery can be charged with the sensor head installed or removed
from the base. (Remember to switch off the monitor before removing
the sensor head).

The Lithium Smart Charger displays a red LED light when charging
and a green LED light when the battery is charged.