49
AEROPRAKT-22L2 Pilot Operating Handbook
A22L2-POH-02
10.7Fiight Training Supplement
Flight
training
on Aeroprakt-22L2 airplane
foresees
5
hours
of flying
in
accordance
with
the
normal flight procedures, described
in
Pilot Operating Handbook (POH).
It
covers the following:
1.
Preflight preparation
including
determining the takeoff mass and airplane CG position,
preflight check and preflight servicing of the airplane
.
2. Airfield traffic and flight to the training area.
3. Airfield circuit flight.
4. Balked
landing
.
5. Low speed flight, recognizing
the
starting and ongoing stall and stall recovery.
6. High speed
flight,
recognizing and recovery from steep diving spiral.
7. Short field takeoff and landing with overflying obstacles.
8. Crosswind
takeoff
and
landing.
9.
Flights with
imitated engine failure.
10.7.1 Preflight preparation
Preflight preparation includes preflight check and
determining
the takeoff mass and CG
position of the airplane
.
It
shall be done
in
accordance with the sections 4.3 and 7.2 before
every flight.
10.7.2 Airfield traffic and flight to the training area
To adapt
to the
airplane controllability and flight characteristics a
flight
(its elements are
described
in
the POH) shall be performed that includes the following:
a) Level flight at various airspeeds and engine power settings.
Elevator
trim
tab shall be used for trimming the airplane
in
pitch
.
b) Climb at various airspeeds and full power of the engine
.
Elevator
trim tab
shall be used for trimming the airplane in pitch
.
c) Descending at various airspeeds,
flap
settings and
minimum
engine power.
Elevator trim tab shall be used for trimming the airplane in pitch.
d) Turns to the left and to the right at various speeds and bank angles.
Total flight time- 40 minutes. Number of flights- 2. Number of landings- 2.
10.7.3 Airfield circuit flight
Airfield circuit flight shall be performed for familiarization with the main flight elements, as
well as takeoff and
landing
.
It
consists of the following:
1. Before starting the engine, the door locks shall be checked along with
the
harness belts,
elevator trim tab lever, parking brake and carburetor heating knob; flaps shall be set to 1st
position, choke
lever
shall be moved forward (if the engine is cold),
then
the master switch
and strobes shall be turned on
.
Fuel
level
and position of the
fuel
valves (at least one must
be open) shall be checked. Then set the ignition
switc
hes
to ON and start the engine. After
engine begins to run smoothly the choke lever shall be moved back (if
it
was
used)
.
Then
switch ON the radio and check communication
.
After engine is warmed to the required
temperature
ignition
system check shall be done
.
Before taxiing the parking brake must be
set to OFF.
Содержание 484
Страница 2: ......
Страница 17: ...17 AEROPRAKT 22L2 Pilot Operating Handbook A22L2 POH 02 Fig 9...
Страница 21: ......
Страница 53: ...53 AEROPRAKT 22L2 Pilot Operating Handbook A22L2 POH 02...