2. Install two wall mount screws (and plastic anchors if necessary). Leave the screw heads far
enough away from the wall so that the bracket will slip over them (you can test this using the
bracket). If you are connecting the device to cables from inside the wall, drill an access hole
in the wall for the cables, if necessary.
3. Attach the device to the bracket by lining up the mount tabs on the bottom of the device
with the corresponding mount tab depressions on the bracket (see illustration above). Slip the
device tabs under the edges of the bracket tab depressions and rotate the device until it
clicks into place on the bracket.
4. Mount the device on the wall or ceiling by slipping the bracket keyholes over the screw
heads and sliding the screws into the narrow part of the keyhole.
To remove the device from the bracket, use a small flat-blade screwdriver or similar tool
to depress the mount clips on the bottom of the device and release it from the bracket,
as shown in the illustration.
Page 8 of 17
AP245X Hardware User Guide
6/14/2016
