
General Information
Subject to Export Control, see Cover Page for details.
1 - 4
1.10.2
Optional Features
•
250 kHz to 3 GHz spectrum analyzer, with custom analysis tools.
•
406 MHz COSPAS / SARSAT Beacon (ELT) Testing.
•
VHF Comm TX & DME TX Analyzer.
•
VHF Datalink Mode-2 digital communications Analyzer.
1.11
INSTALLATION
1.11.1
General
The following is a general installation process for the Test Set
STEP PROCEDURE
1.
Place the Test Set on a suitable flat, clean and dry surface.
2.
If the Test Set is to be mounted in an equipment cabinet, attach provided
instrument rack mountings.
3.
With equipment mounted or on bench top, attach interface cables to the
appropriate RF ports.
4.
For remote operation, attach GPIB cable to the Test Set and external control
computer bus.
5.
Furnish electrical power to the Test Set. Connect AC power cable to rear power
input. Apply 100 to 240 VAC at 50 to 60 Hz.
1.11.2
Safety Precautions
Listed are several safety precautions which must be observed during installation and
operation. Aeroflex assumes no liability for failure to comply with any safety precautions
outlined in this manual.
Complying with Instructions
Installation/operating personnel should not attempt to install or operate the Test Set
without reading and complying with all instructions contained in this manual. All
procedures must be performed in exact sequence and manner described.
Grounding Requirements
To minimize shock hazard, all equipment chassis and cabinets must be connected to
electrical ground. All Aeroflex test sets are equipped with a standard three-prong power
cable which must be connected to a prop erly grounded three-prong wall receptacle.
It is the customer's responsibility to:
•
Have a qualified electrician check wall receptacle(s) for proper grounding.
•
Replace any standard two-prong wall receptacle(s) with properly grounded three
prong receptacle(s).
WARNING: DO NOT USE A THREE PRONG TO TWO-PRONGADAPTER PLUG. DOING SO CREATES A
SHOCK HAZARD BETWEEN THE CHASSIS AND EARTHGROUND.
Содержание ATB-7300
