AERMEC VEC, Техническое руководство

Страница: 6 / 39

6
E
nglish
The fan coils are shipped in standard package which consists of expanded polystyrene foam and cardboard shells.
PACKAGING
Consult control panel manual for installation and use instructions.
USE
WARNING: electrical wirings, installa-
tion of the fan coils and relevant acces-
sories should be performed by a tech-
nician who has the necessary technical
and professional expertise to install,
modify, extend and maintain systems,
and who is able to check the systems
for the purposes of safety and correct
operation.
WARNING: the fan coil is connected to
the power supply and a water circuit.
Any operation by persons who do not
possess the required technical skills can
lead to personal injury to the operator
or damage to the unit and surrounding
objects.
WARNING:before carrying out any
work, wear the proper personal protec-
tive equipment.
WARNING: the appliance must be fitted
according to the national regulations on
process plant engineering.
WARNING: check that the power sup-
ply is disconnected before carrying out
any procedures on the unit.
WARNING: install a device, main
switch or plug which allows to comple-
tely cut off the power supply from the
unit.
WARNING! DANGER! Any use of the
unit not expressly indicated by Aermec
is strictly prohibited.
MALFUNCTIONS
In the event of a malfunction, cut off
power supply to the unit, then restore
the power and start the unit again. If
the problem occurs again, call the local
After-Sales Service immediately.
POWER THE FAN COIL ONLY WITH
230 VOLT, SINGLE PHASE, 50 Hz
Any other type of power supply could
permanently damage the fan coil.
DO NOT TUG THE ELECTRIC CABLE
It is very dangerous to pull, tread on or
crush the electric power cable, or fix it
with nails or drawing pins.
A damaged power cable can cause short
circuits and injure people.
D O N OT O B S T R U C T T H E A I R
OUTLETS BY PLACING OBJECTS INTO
THEM
Do not put anything in the air outlet
slots.
This could injure people and damage
the fan.
D O N OT U S E T H E FA N C O I L
IMPROPERLY
Do not use the fan coil for animal
husbandry applications (e.g. incubation).
AIR THE ROOM
Periodically air the room in which
the fan coil has been installed. This is
particularly important if the room is
occupied by many people, or if gas
appliances or sources of odours are
present.
ADJUST TEMPERATURE ADEQUATELY
The room temperature should be
adjusted in order to provide maximum
comfort to the people in the room,
especially if they are elderly, children
or sick people; avoid differences over
7°C between the outdoor temperature
and the temperature inside the room in
summer.
Carefully choose the room temperature
so as to save energy.
C O R R E C T A I R J E T A I M I N G
ADJUSTMENT
Air coming out from the fan coil must
not reach people directly; in fact, even
if the air is warmer than the room
temperature, it could cause a cold
sensation and result in discomfort.
DO NOT USE EXCESSIVELY HOT
WATER
To clean the indoor unit, use soft cloths
or sponges dampened with water at a
maximum of 40°C. Do not use chemical
products or solvents to clean any part of
the fan coil. Do not spray water on the
outer or inner surfaces of the fan coil (it
might cause short circuits).
CLEAN THE FILTER FREQUENTLY
Cleaning the filter frequently guarantees
enhanced operating efficiency.
Check whether the filter is very dirty: if it
is, clean it more often.
Clean frequently; remove the accumula-
ted dust with a vacuum cleaner.
Once the filter is clean, refit it to the fan
coil following the removal instructions
but in reverse order.
The normal wear and tear of germicidal
lamps and filter is not covered by the
warranty.
SUPPLEMENTARY CLEANING
The possibility to remove the basin and
the shrouds of the examinable fans (done
only by suitably trained and qualified
personnel) allows to thoroughly clean
even the internal parts - an essential con-
dition when the unit is installed in very
crowded areas or places requiring high
standards of hygiene.
WHAT IS NORMAL
In the cooling function, water vapour
may be present in the air delivery of the
fan coil.
In the heating function, a slight hiss
might be heard close to the fan coil.
Sometimes the fan coil might give off
unpleasant smells due to the accumu-
lation of substances present in the air
of the room (clean the filter more often,
especially if the room is not ventilated
regularly).
While the unit is functioning, there
could be noises and creaks inside
the device due to the various thermal
expansions of the elements (plastic and
metal), but this does not indicate any
malfunction and does not damage the
unit unless the maximum input water
temperature is exceeded.
IMPORTANT INFORMATION