29 / 36
TF6089_B
Aereco S.A.
10.3. FRESH AIR INLET AND EXHAUST AIR OUTLET
The fresh air intake and the used air discharge must be in direct contact with the outdoor,
and not in an attic, garage, or crawl space.
The fresh air intake of the installation must be:
·as far as possible from sources of pollution and air discharges (at least 3m from the ground);
·if possible, on a protected façade.
The exhaust air, for its part, must be far from air intakes (fresh air inlet, doors and windows); it must
not be a nuisance for the occupants. If possible, use a different façade from the air intake in order to
avoid mixing between the fresh air and the stale air.
We recommend taking the prevailing winds into account, in order to avoid an overpressure in the
supply or exhaust duct (discharge up, or horizontal, and favourably oriented with respect to the
prevailing winds).
Requirement for fresh air inlet / exhaust air outlet grilles:
·Ø 160 mm
·less than 20 Pa at 230 m
3
/h
The use of a double used air/fresh air duct is not recommended for this type of installation
(Make sure that it avoids the mixing between the intake of fresh air and the discharge of
used air).
11.
ENVIRONMENTAL CONCERNS
Recycle of electrical and electronic equipment waste at the end of its lifecycle (applicable in the
countries of the European Union and other countries with special collection centre).
The symbol on the appliance indicates that this appliance should not be treated as domestic
waste. It must be taken to a special collection centre for the recycling of electrical and electronic
equipment. For further information on the treatment, recovery and recycling of this product,
contact your competent local office, the household waste collection service or the shop where you
purchased the appliance.
12.
WARRANTY
This guarantee is valid for two years from the original date of purchase of your appliance, for faults
of the appliance, which have been caused by faulty construction. On these conditions, Aereco
guarantee the replacement or the supply of the equipment found to be defective after inspection by
its after sales service. In any case, the warranty may not cover additional costs, of labour, transport
or compensation of any kind. The warranty does not cover damage due to improper installation
in this manual, improper use or attempted repair by unauthorized personnel. In case of problems,
please contact your installer or your reseller.
13.
CONFORMITY AND STANDARD
The DXR heat recovery system is CE certified. It has also received specific certifications in several
countries (available on demand).
The choice of accessories associated with the heat recovery system must comply with the standards
in force in the country, and preferably be certified, when such certification exists.
