AEQ
PHOENIX STRATOS
83
6. QUICKSTART USER’S GUIDE. REMOTE CONTROL.
To gain a complete grasp of the PHOENIX STRATOS, we recommend reading the previous
chapters and “AEQ ControlPHOENIX” user’s manual carefully. The paragraphs below describe
the basic actions you will need to take for remote operation of the equipment by means of
“AEQ ControlPHOENIX” application. IMPORTANT NOTE: For that purpose, the equipment
must be previously configured to accept remote control connections (see section 3.1.7 of this
manual).
6.1. Equipment connections.
6.1.1. Power supply.
The two 3-pin IEC power feed connectors are located on the back panel of the codec.
Connecting one is enough.
6.1.2. Communications interfaces.
Depending on the type of communication, a certain type of connection will be needed:
•
IP connection: Connect Ethernet cable (CAT5 or higher) terminated in an RJ45 10/100
BT connector to the connector installed for this purpose in the rear panel of the unit.
The selected cable will be the direct type if the connection is made from the unit to a
communications device of the switch or router type. For further information on the
pinout, see section 2.2.7 of this manual.
•
ISDN connection: Connect standard cable terminated in an RJ11 or RJ45 connector to
one of the two connectors made available for this purpose in the rear section of the
ISDN module, according to the protocol and standard to be used (see section 2.2.8).
•
V.35 connection: Connect standard cable terminated in a DB25 connector to the
connector installed for this purpose in the rear section of the unit (see section 2.2.5).
6.2. Powering up the codec.
•
Once the codec has been connected to the mains, after about 15 seconds, the OLED
screen in the display will turn on, showing the AEQ logo and the name of the unit.
•
After a few seconds, the MAIN STATUS menu screen will be displayed. Check to see
that there is no ERROR message (the screen has dimmed lighting, press any key to
see it properly).
•
Configure the unit to accept remote control (see section 3.1.7 of this manual).
•
The unit is ready to be used.
