AEQ
PHOENIX STRATOS
73
selected as a backup, this destination will be defined by an ISDN
subscriber number, a SIP identifier (URI) or an IP address.
o
Enter the number of the contact to be called, either manually or from the
internal phone book in CALL BOOK.
•
Press the CALL button on the front panel again, or select the DIAL option on screen, to
make the call.
If you select the number to call from the phone book, you can perform the same action
by using the contextual button associated with the DIAL option.
•
You can monitor the status of the call in the OLED screen:
o
CALLING.
o
CONNECTING (depending on the communication interface, this may be an
extremely brief status).
o
SYNCHRONIZING (depending on the communication interface, this may be an
extremely brief status).
o
CONNECTED.
Detail of Phoenix STRATOS calling
•
Verify that the SYNC LED beneath the CALL button is lighted in green to indicate that
the communication has been successfully established.
•
Press the ON AIR button associated with that communications channel to enable audio
to be transmitted over that interface in full duplex mode.
•
Once the connection has been established with the remote end, confirm the presence
of transmitted and received audio by checking the VU meters on the Phoenix
STRATOS front panel.
o
If necessary, adjust the levels in AUDIO SETTINGS
CODEC CHANNEL1
SETTINGS (or CODEC CHANNEL2 SETTINGS) menu or in ANALOG AUDIO
SETTINGS menu, according to the desired signal type.
5.3.1. Finalizing an ISDN communication.
•
To finalize the communication, simply press the CALL button associated with the
communications currently being used on the unit’s front panel.
5.3.2. Reception and acceptance of an ISDN communication.
If the ISDN interface of the codec is suitably configured and the automatic answering mode is
OFF, when a call is received:
•
The unit will emit an audible notification signal. This signal can be disabled in MENU
SYSTEM
8-SETTINGS
BUZZER.
•
The red CALL button light corresponding to the communications channel that receives
the call will blink simultaneously to notify you.
•
The caller’s information will appear on the OLED screen:
o
The communications interface through which the call is being received.
o
The communications channel through which the call is being received. The
channels and interfaces are associated in MENU SYSTEM
6-CHANNELS
Chn1 or Chn2
INTERFACE.
o
The calling number identifier.