Power Quality Analyzer Model 3945
29
• Press the button to apply the current sensor selection. The Confi guration
menu will once again be displayed on the screen.
NOTE:
In addition to the 4 current probe choices, there is an adapter selection.
This selection allows the operator to use current probes that have a current
output with PowerPad™. The ratio for these probes can be programmed with this
selection. The primary current can be programmed from 5 to 2999 Amps. The
secondary current can be set to 1 or 5 Amps. Adjustment for the ratio is performed
in the same way as described on the previous page for the MN probe.
4.1.7 Baud
Rate
• Highlight BAUD RATE with the
buttons, then press the
button.
• Choose from the baud rate values: 300, 2400, 4800, 7200, 9600, 19200, 38400,
57600 or 115200 with the
buttons.
• Press the button to apply the current sensor selection. The Confi guration
menu will once again be displayed on the screen.
4.1.8 Recording
• Highlight RECORDING with the
buttons, then press the
button.
The following screen will appear:
SET-UP
Hz
Hz
Figure 4-5
• Four recording set-ups are available.
• Choose recording confi guration 1, 2, 3, or 4 with the
buttons.
• Next, move through the choices with the
buttons and select the desired
parameters with the
buttons.
As you move through the parameters, each choice, in turn, will be highlighted.
If these options are not
selected, all the harmonics
(odd and even) will be
recorded.
