AEMC OX 7102 III, Руководство пользователя

Страница: 83 / 226

Oscilloscope Mode - The "Display" Menu
SCOPIX IV - 83
Oscilloscope Mode (cont'd)
Full screen
Switches from the normal display mode to the “full screen” display mode and
vice versa.
The display is organized so as to leave the biggest surface area possible for
trace plotting: only the permanent settings and the automatic or manual
measurements remain.
•
This function has the same effect as the
key.
•
The “
”
symbol indicates that the full screen mode is active.
This function can also be called up by double-pointing with the stylus on the
trace display area.
The settings defined on the front panel remain active.
The following sub-menus can be used to switch from oscilloscope to XY mode.
The “ ” symbol indicates the active mode.
Oscilloscope
This is the basic operating mode.
XY
The “XY source” menu is used for assigning the desired traces to the
X axis (horizontal) and Y axis (vertical).
Validation of the selections by "
OK
". Exit from the menu without modification
by "
Cancel
".
•
Each axis is graduated into 8 divisions
.
•
The selected traces are identified by a figure corresponding to their axis
.
•
The
“ ”
symbol indicates the trace selected for each axis.
Example
Two sinusoidal
signals assigned to
the X and Y axis with
an offset of
π
/2 are
then represented by
a circle.
Example of
Accumulate mode
In Accumulate mode the Reference memory , the Full screen and
the ROLL mode are not active.
www.
ShopAEMC
.com
Shop for AEMC products online at:
1.877.766.5412