AEM 26-3000C, Руководство по установке

Страница: 3 / 7

3
Read and understand these instructions BEFORE attempting to install this product. Failure to
follow installation instructions and not using the provided hardware may damage the kit com-
ponents and engine.
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set the parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Do not discard stock components after removal of the factory
system.
f. Open the charge pipe kit package and make sure all parts are
included.
2. Removal of stock system
a. Remove factory fresh air inlet duct
b. Remove fan using a 10mm socket as shown. Once the
two top bolts are removed and the power harness at the
bottom is disconnected, the fan can be lifted out of the
engine compartment and set aside.
c. Use the 12mm socket with a U-joint and extension to
remove the bolts securing the charge pipe flange to the
turbocharger. d. Remove the vacuum line to the recirculation valve
and set aside (cap steel line with provided cap (Item 9) if
desired) as well as the other two lines shown above and
loosen the clamp between the valve and the factory
charge pipe enough for the clamp to move freely.
Tools Needed:
Flat Screw Driver 12” Socket Extension
10mm Socket Side Cutters
12mm Socket
Socket U-Joint
Socket Driver
Pliers