AEG EPN09C38HW, Руководство по установке

Страница: 8 / 112

8 www.electrolux.com
3.1 Indoor unit installation
3.1.1 Installing the Wall
Mounting Plate
1. Install the wall mounting plate
horizontally over the structural parts
on the wall using the spaces indicated
on the plate, as shown in Fig.3.1.1.
2. In the case of tiled, concrete or
similar walls, create 5mm diameter
holes. Place anchor supports for the
appropriate assembly screws.
3. Install the wall mounting plate to the
wall with screws.
Fig.3.1.1
NOTE:
• Fit the wall mounting plate and drill
holes in the wall according to the wall
structure and corresponding mounting
points on the wall mounting plate.
• Refer to Appendix(1) for type details
about the mounting plates.
3.1.2 Drilling the Hole
1. Determine the position of the hole
for the pipes using the wall mounting
bracket and drill the pipe hole so that it
is tilted slightly downward.
2. Always use a pipe cover with an
opening when drilling.
Fig.3.1.2
P
P
Wall
Indoor
Outdoor
3. PRODUCT INSTALLATION
3.1.3 Connective pipe
1. For the left-hand and right-hand
piping, remove the pipe cover from the
side panel. The pipe cover can be kept
as it may be used when relocating the
air conditioner to any other place.
2. For the rear-right-hand and rear-
left-hand piping, install the piping
as shown in Fig.3.1.3-1. Bend the
connective pipe to be laid at a height
of 43mm or less from the wall. Fix the
end of the connective pipe.
Fig.3.1.3-1
Pipe Cover
(right)
Right
Piping
Rear Right
Piping
Rear Left
Piping
Pipe Cover
(left)
Pipe Holder
Fig.3.1.3-2
Indoor Unit
Outline
Connective Pipe
43mm
3.1.4 Drainage
1. Run the drain hose sloping downward.
Do not install the drain hose as
illustrated in Fig.3.1.4.
Fig.3.1.4
Do not block water flow by a rise or
put the end of drain hose into water.