AEG CKB600A4BM, Руководство пользователя

Страница: 26 / 32

13.14 Anti-tilt protection
Set the correct height and area for the
appliance before you attach the anti-tilt
protection.
CAUTION!
Make sure you install the
anti-tilt protection at the
correct height.
Make sure that the surface
behind the appliance is
smooth.
You must install the anti-tilt protection. If
you do not install it, the appliance can
tilt.
Your appliance has the symbol shown on
the picture (if applicable) to remind you
about the installation of the anti-tilt
protection.
1. Install the anti-tilt protection 325 -
330 mm down from the top surface
of the appliance and 110 - 115 mm
from the side of the appliance into
the circular hole on a bracket. Screw
it into the solid material or use
applicable reinforcement (wall).
110-115
mm
325-330
mm
2. You can find the hole on the left side
at the back of the appliance. Lift the
front of the appliance and put it in
the middle of the space between the
cupboards. If the space between the
bench cupboards is larger than the
width of the appliance, you must
adjust the side measurement to
centre the appliance.
If you changed the
dimensions of the cooker,
you must align the non-tip
device correctly.
CAUTION!
If the space between the
bench cupboards is larger
than the width of the
appliance, you must adjust
the side measurement to the
centre of the appliance.
13.15 Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
Connection to the mains
1.
Fit the power cable with a
standardized plug suitable for the
load indicated on the data label.
2. Connect the wires as shown below.
3. Remember that the earth wire must
be longer than the phase wires
letter L (phase) = brown wire
letter N (neutral) = blue wire
symbol
(earth)
= green/yellow
wire
www.aeg.com 26