--------------------------------------------------------------------------------4/5--------------------------------------------------------------------------------
The available baudrates are:
0
4800
1
9600
2
19200
3
38400
3.7
Warmstart with saved parameters
With this command the AMP 4/8 restarts with the saved parameters.
instruction:
RST <CR>
answer:
<CR>
4
Startup and testing the AMP 4/8
•
Connect the reader via cable with the serial interface (COM) from your notebook or pc.
•
Connect the reader with your power supply (9..30V DC). Look after the polarity!
•
Switch the power supply on. The yellow LED of the AMP starts to blink.
•
Start your terminal programme. You have to set the following settings: 8 data bits, 1 start bit
und 1 stop bit, no parity check (often called 8N1), baud rate 19200 baud, no flow control(e.g.
XOFF/XON).
•
Send the command „VER <CR>“ to the AMP. The reader answers with the actual firmware
version (e.g. AEG ID AMP8 V1.3).
•
Change to mode 1 with the command “MO 1” (the default value is MO 2)
•
With the command “MP 1” .. “MP 8” you can change the antenna channels.
