AEG ID ARE DT1 LF, Руководство по установке

Страница: 15 / 28

--------------------------------------------------------------------------------15/28--------------------------------------------------------------------------------
Note: The internal reference number is deleted in the following conditions:
•
after a cold start
•
after a warm start (command line RST <CR>)
•
after entering the command line CID <SP> 1 <CR>
This causes that the next transponder code is output definitely.
Note: The filter function CID picks up the results of the complete reading cycles , while the parameter
NID proceeds from the results of single readings ! The filter function CID has effect on the serial in-
terface only.
3.3.2 CN – suppression of No Reads
Through the setting CN=1 the NoRead results after a get tag command or in MD0 mode are sup-
pressed on the serial interface. The leds are not influenced by this command.
Input format: CN <SP> parameter <CR>
Output (example):
0
<CR>
Parameter:
PARAMETER FUNCTION
0 No suppression
1 Suppression of equal transponder numbers